Push-in fitting, thread G 1/2", tube 10 mm, nickel plated brass, stainless steel gripping claws

The push-in fitting connects the male thread G 1/2" and a tube of 10 mm outside diameter. The material is nickel plated brass, the size is fixed at tube diameter 10 mm. The elbow design turns the line by 90 degrees and saves installation length. The version is fixed with seal NBR.

Benefits

• The connection over male thread G 1/2" is fixed in size and needs no adaptor
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring

Applications

Water and cooling circuits, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.