Adjustable T connector with cone, tube 18 L, zinc-plated steel, no nut or ring

This adjustable T connector splits a line into two paths and joins the tube to a tube stud with a sealing cone and an O-ring. The data state a working pressure of 315 bar. The stated material is zinc-plated steel. This version is supplied with light series and scope of delivery without nut and cutting ring.

Benefits

• The tee branches the line off without needing a second port on the device.
• The branch can be set to any direction before it is locked, so tube 18 L (M26x1,5) stays free of stress.
• Sealing cone with an O-ring at tube stud 18 L for a soft joint that can be undone repeatedly.
• Working pressure up to 315 bar in the light series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

At tube stud 18 L of a plant of the light series the branch sits where a further circuit is to be connected later.

Standards and conformity

Before assembly the stud thread and cone, the inside of the union nut and the cutting ring are oiled. Thin-walled or soft tubes need a reinforcing sleeve.