Push-in fitting, cross design, with EPDM seal, tube 12 mm, POM, FDA compliant

This push-in fitting joins a tube of 12 mm outside diameter and the continuing line in one part. The operating pressure reaches from -0.95 bar to 11 bar. The cross design distributes the medium to three outlets.

Benefits

• The seal in EPDM is matched to the range from -0.95 bar to 11 bar
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 11 bar is released for this size
• POM, FDA compliant keeps the parts light and dimensionally stable in the range from -0.95 bar to 11 bar
• One part serves three outlets and saves additional joints

Applications

Compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61.