Clamping nut - Riegler K1137

Clamping nut. This range covers 4 variants from 0.17 EUR. Select the version you need above.

Available variants

Shared technical data

About Clamping nut

The clamping nut holds the hose fitting together and presses the clamping ring onto the hose. It is needed both as an assembly part and as a spare for the POM fitting range and covers hose 6/4 to 12/9 mm. Operating pressure is 0 to 10 bar.

What matters when choosing

• Thread: M10x1.0 male plus M12x1.0, M14x1.0 and M16x1.0 female. The nut has to match the thread of the fitting already installed.
• Hose size: tube outside diameter 6 to 12 mm with inside diameter 4 to 9 mm. Thread and hose size belong together, so check both figures against the hose in use.
• Width across flats: AF 12 to AF 19 depending on size. In a tight installation this dimension is worth checking before ordering.
• Material POM: light, dimensionally stable and abrasion resistant, the temperature range stated for the items is -10 °C to 60 °C. The range is not meant for media that attack the plastic.
• Operating pressure: 0 to 10 bar. Above that a metal fitting belongs in that position.

Typical applications

• Spare part for repairs on POM hose fittings
• Low pressure air lines in conveying and packaging equipment
• Water and coolant lines at low pressure
• Dosing and laboratory setups using soft hose
• Retrofitting and rebuilding hose lines on test assemblies

All four nuts are made from POM and come from German production.