Push-in fitting, straight design, with EPDM seal, tube 4 mm, second port 4 mm, POM, FDA compliant

The push-in fitting accepts a tube of 4 mm outside diameter and a second tube of 4 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 16 bar. The straight design carries the medium through the part without deflection.

Benefits

• The design metrisch - metrisch is clearly designated in the data sheet
• Approvals to FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61 are documented for the materials
• The seal in EPDM is matched to the range from -0.95 bar to 16 bar
• The tube is pushed in without tools and released again over the release ring

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61.