Adjustable T connector with cone, tube 20 S, zinc-plated steel, no nut or ring

The adjustable T connector splits a line into two paths and joins the tube to a tube stud with a sealing cone and an O-ring. This version comes with tube stud 20 S and tube connection 20 S (M30x2). A further figure is a temperature range of -35 to +100 °C. This version is supplied with heavy series and scope of delivery without nut and cutting ring.

Benefits

• The tee branches the line off without needing a second port on the device.
• The branch can be set to any direction before it is locked, so tube 20 S (M30x2) stays free of stress.
• Sealing cone with an O-ring at tube stud 20 S for a soft joint that can be undone repeatedly.
• Working pressure up to 400 bar in the heavy series.
• Temperature range -35 to +100 °C for the body in zinc-plated steel.

Applications

At tube stud 20 S of a plant of the heavy series the branch sits where a further circuit is to be connected later.

Standards and conformity

Before assembly the stud thread and cone, the inside of the union nut and the cutting ring are oiled. Thin-walled or soft tubes need a reinforcing sleeve.