Cylindrical drill bush DIN 179 form B, bore 16 mm, length 16 mm, outside dia 26 mm

Where a hole of 16 mm has to sit in the same place on every part, this DIN 179 bush guides the tool. The short length of 16 mm supports the drill, and the bore is rounded on both sides.

Benefits

• Special case-hardening steel, hardened to 740 ± 80 HV 10 and ground
• Guide bore of 16 mm to DIN 179 for the matching tool
• Outside diameter of 26 mm as a ground seat in the drill plate
• Bore rounded on both sides to form B, so the bush can be fitted either way round
• Dimensions to DIN 179, so existing bushes can be replaced size for size

Applications

• Series drilling on jigs with high piece numbers
• Drill templates for assembly work on site
• Guiding twist drills and reamers in the jig
• Repair of worn drill plates by replacement of the same size

Standard and material

The bush is made to DIN 179 in form B, and the bore is rounded on both sides. The material is special case-hardening steel, hardened to 740 ± 80 HV 10 and ground.