Autogen. set 17 mm, weld. 0.5-9 mm, cutt. 3-100 mm, block nozzle - Riegler 149612

Autogenous welding box, 17 mm, 5 welding inserts 0.5 - 9 mm, butterfly cutting insert 3-100 mm, block nozzles, handle, accessories Welding and cutting torches are used for welding, cutting, soldering, and heating. They are suitable for all industrial and craft applications. The standard torch, with a 17 mm shaft diameter, is the most common size. The oxyacetylene flame reaches temperatures of up to 3100 °C. Our autogenous welding sets are equipped with the following products:HandleWelding inserts in eight different sizes from 0.5 to 30 mm welding rangeCutting inserts with ring or block nozzles, as well as wing or lever actuation for cutting oxygen, with cutting ranges from 3 to 100 mmAccessories: Guide carriage with round guide, gas lighter, replacement seals The autogenous welding sets can alternatively be equipped with pipe welding inserts or other products individually according to customer requirements on request.

Standards and origin

• Customs tariff number: 84689000
• Country of origin: TR

About Autogenous welding and cutting torch sets

Oxy-fuel welding and cutting torch sets bring the handle, welding inserts, cutting insert and accessories together in one box. Welding, cutting, brazing and heating are covered with a single tool and without electrical power on site. All sets use the 17 mm shank diameter, the most common size of the standard torch.

What matters when choosing

• Welding range: the sets differ in the number of welding inserts and therefore in the material thickness covered, from 0.5 to 4 mm with three inserts up to 0.5 to 30 mm with eight. The deciding factor is the thickest section welded regularly.
• Cutting range: 3 to 100 mm across all sets. The range is covered by the cutting insert supplied with the respective box.
• Nozzle type: ring nozzles or block nozzles. The choice follows the equipment already in use, so replacement nozzles from your own stock still fit.
• Cutting insert: wing or lever version. The lever insert sits steadier in the hand on longer cuts, the wing version is more compact.
• Gas type and shank diameter: both are stated per item and have to match the existing cylinder and hose equipment before a set is ordered.

Typical applications

• Cutting structural steel up to 100 mm thick in workshops and maintenance
• Oxy-fuel welding of thin walled sheet and tube
• Brazing pipe joints in plant construction
• Preheating and flame straightening of parts before further work
• Assembly and repair jobs with no power supply on site

The group also holds an empty box in DKP steel measuring 470 x 213 x 86 mm, useful for reorganising equipment already on hand. All 9 items are produced in Turkey.