Dowel pin DIN 6325 / ISO 8734, 3.0 x 18 mm, hardened and ground steel

The dowel pin fixes the position of two components relative to each other and takes up transverse forces and follows DIN 6325. The data state a diameter of 3.0 mm. Material hardened and ground steel is listed for this version.

Benefits

• Diameter 3.0 mm to DIN 6325 for a tight fit in the reamed bore.
• Length 18 mm so that the pin reaches through both parts.
• Radius R 3.0 mm at the end face to DIN 6325.
• The dimensions L1 1.10 mm and L2 0.45 mm are laid down for this size.
• Hardened and ground, so the fit stays tight even after repeated assembly.

Applications

In mechanical engineering the 3.0 x 18 mm pin sits in the reamed bore and takes transverse forces out of the joint.

Standards and conformity

Diameter 3.0 mm and length 18 mm comply with DIN 6325 and ISO 8734.