Push-in fitting, Y design, male thread M 5, tube 6 mm, PVDF, for pipe and tube

This push-in fitting joins the male thread M 5 and a tube of 6 mm outside diameter in one part. The material is PVDF, the size is fixed at tube diameter 6 mm. The Y design splits the line into two outlets.

Benefits

• The size 6 is clearly assigned and stays available for reordering
• The connection over male thread M 5 is fixed in size and needs no adaptor
• With tube diameter 6 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.