Push-in fitting, Y design, male thread G 3/8", tube 10 mm, PVDF

The push-in fitting brings the male thread G 3/8" and a tube of 10 mm outside diameter together. The material is PVDF, the size is fixed at tube diameter 10 mm. The Y design splits the line into two outlets.

Benefits

• One part serves two outlets and saves additional joints
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 10 is clearly assigned and stays available for reordering
• The connection over male thread G 3/8" is fixed in size and needs no adaptor
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.