Push-in fitting, Y design, with EPDM seal, tube 8 mm, POM, FDA compliant

The operating pressure reaches from -0.95 bar to 16 bar. The push-in fitting connects a tube of 8 mm outside diameter and the continuing line in doing so. The Y design splits the line into two outlets.

Benefits

• Approvals to FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61 are documented for the materials
• The seal in EPDM is matched to the range from -0.95 bar to 16 bar
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 8 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 16 bar is released for this size

Applications

Workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61.