Push-in fitting, Y design, tube 6 mm, second port 6 mm, stainless steel

The material is stainless steel. The push-in fitting connects a tube of 6 mm outside diameter and a second tube of 6 mm outside diameter in doing so. The Y design splits the line into two outlets.

Benefits

• The size 6 is clearly assigned and stays available for reordering
• With tube diameter 6 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.