Push-in fitting, Y design, tube 12 mm, second port 12 mm, stainless steel

The push-in fitting accepts a tube of 12 mm outside diameter and a second tube of 12 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is stainless steel, the size is fixed at tube diameter 12 mm. The Y design splits the line into two outlets.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 12 is clearly assigned and stays available for reordering
• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.