Push-in fitting, elbow design, male thread NPT 1/8", tube 8 mm, stainless steel 1.4404

The operating pressure reaches from -0.95 bar to 15 bar. The push-in fitting connects the male thread NPT 1/8" and a tube of 8 mm outside diameter in doing so. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The material stainless steel 1.4404 stays resistant without additional coating in the range from -20 °C to +150 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.