Push-in fitting, elbow design, male thread M 7, tube 6 mm, nickel plated brass

The push-in fitting brings the male thread M 7 and a tube of 6 mm outside diameter together. The operating pressure reaches from -0.95 bar to 15 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The operating pressure from -0.95 bar to 15 bar is released for this size
• The temperature range from -20 °C to +70 °C covers cold installation and warm machine surroundings
• Nickel plated brass as material covers the released range from -20 °C to +70 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The seal in NBR is matched to the range from -20 °C to +70 °C
• The tube is pushed in without tools and released again over the release ring

Technical data

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.