Push-in fitting, elbow design, male thread M 5, tube 6 mm, stainless steel

The push-in fitting accepts the male thread M 5 and a tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is stainless steel, the size is fixed at tube diameter 6 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 6 is clearly assigned and stays available for reordering
• The connection over male thread M 5 is fixed in size and needs no adaptor

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.