Push-in fitting, elbow design, long design, male thread R 1/2", tube 16 mm, nickel plated brass

The material is nickel plated brass, the size is fixed at tube diameter 16 mm. The push-in fitting connects the male thread R 1/2" and a tube of 16 mm outside diameter in doing so. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The size 16 is clearly assigned and stays available for reordering
• The connection over male thread R 1/2" is fixed in size and needs no adaptor
• With tube diameter 16 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring

Applications

Workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.