Push-in fitting, elbow design, male thread G 1/8", tube 4 mm, nickel plated brass, -0.95 bis 15 bar

The push-in fitting accepts the male thread G 1/8" and a tube of 4 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 15 bar. The elbow design turns the line by 90 degrees and saves installation length. The version is fixed with -20 bis +150 °C.

Benefits

• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• Nickel plated brass as material covers the released range from -20 °C to +150 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The seal in NBR is matched to the range from -20 °C to +150 °C

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.