Push-in fitting, elbow design, male thread G 1/2", tube 12 mm, stainless steel

The material is stainless steel. The push-in fitting connects the male thread G 1/2" and a tube of 12 mm outside diameter in doing so. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 12 is clearly assigned and stays available for reordering
• The connection over male thread G 1/2" is fixed in size and needs no adaptor
• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.