Push-in fitting, elbow design, male thread G 1/2", tube 10 mm, nickel plated brass, -20 bis +80 °C

The push-in fitting brings the male thread G 1/2" and a tube of 10 mm outside diameter together. The temperature range reaches from -20 °C to +80 °C. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The temperature range from -20 °C to +80 °C covers cold installation and warm machine surroundings
• Nickel plated brass as material covers the released range from -20 °C to +80 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C
• The tube is pushed in without tools and released again over the release ring

Technical data

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.