Push-in fitting, elbow design, tube 8 mm, nickel plated brass, -20 bis +80 °C

The push-in fitting brings a tube of 8 mm outside diameter and the continuing line together. The temperature range reaches from -20 °C to +80 °C. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• Nickel plated brass as material covers the released range from -20 °C to +80 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 8 mm the size is fixed, so no reworking of the line is required

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.