Push-in stem connector, elbow design, tube 4 mm, second port 4 mm, nickel plated brass, seal NBR

This push-in stem connector joins a tube of 4 mm outside diameter and a second tube of 4 mm outside diameter in one part. The material is nickel plated brass, the size is fixed at tube diameter 4 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The change of direction by 90 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required

Applications

Workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.