Push-in fitting, elbow design, tube 3 mm, nickel plated brass

The material is nickel plated brass, the size is fixed at tube diameter 3 mm. The push-in fitting connects a tube of 3 mm outside diameter and the continuing line in doing so. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• With tube diameter 3 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring
• The size 3 is clearly assigned and stays available for reordering

Applications

Workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.