Push-in stem connector, elbow design, tube 10 mm, nickel plated brass, -20 bis +80 °C

The push-in stem connector brings a tube of 10 mm outside diameter and a second tube of 10 mm outside diameter together. The temperature range reaches from -20 °C to +80 °C. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• Nickel plated brass as material covers the released range from -20 °C to +80 °C
• The change of direction by 90 degrees saves installation length ahead of the port
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.