Push-in fitting, elbow design, tube 10 mm, nickel plated brass

This push-in fitting is designed for a tube of 10 mm outside diameter and the continuing line. The part accepts the tube without tools and holds it by the gripping claws. The material is nickel plated brass, the size is fixed at tube diameter 10 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The change of direction by 90 degrees saves installation length ahead of the port
• The tube is pushed in without tools and released again over the release ring
• The size 10 is clearly assigned and stays available for reordering
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required

Applications

Water and cooling circuits, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.