Push-in fitting, elbow design, with EPDM seal, tube 10 mm, POM, FDA compliant

This push-in fitting is designed for a tube of 10 mm outside diameter and the continuing line. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 11 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The operating pressure from -0.95 bar to 11 bar is released for this size
• POM, FDA compliant keeps the parts light and dimensionally stable in the range from -0.95 bar to 11 bar
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61 are documented for the materials
• The seal in EPDM is matched to the range from -0.95 bar to 11 bar

Applications

Water and cooling circuits, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61.