Push-in fitting, elbow design, tube 10 mm, PVDF, for lubricated and unlubricated compressed air

This push-in fitting joins a tube of 10 mm outside diameter and the continuing line in one part. The material is PVDF, the size is fixed at tube diameter 10 mm. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• With tube diameter 10 mm the size is fixed, so no reworking of the line is required
• The change of direction by 90 degrees saves installation length ahead of the port
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 10 is clearly assigned and stays available for reordering

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.