Push-in fitting, bulkhead design, miniature design, thread M 12x1, tube 6 mm, nickel plated brass

The push-in fitting accepts the bulkhead thread M 12x1 and a tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is nickel plated brass, the size is fixed at tube diameter 6 mm. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 6 is clearly assigned and stays available for reordering
• The connection over bulkhead thread M 12x1 is fixed in size and needs no adaptor
• With tube diameter 6 mm the size is fixed, so no reworking of the line is required

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.