Push-in fitting, bulkhead design, thread M 24x2, tube 12 mm, nickel plated brass, elbow design

This push-in fitting is designed for the bulkhead thread M 24x2 and a tube of 12 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is nickel plated brass, the size is fixed at tube diameter 12 mm. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• With tube diameter 12 mm the size is fixed, so no reworking of the line is required
• The bulkhead panel may be up to 11 mm thick
• The tube is pushed in without tools and released again over the release ring
• The size 12 is clearly assigned and stays available for reordering
• The connection over bulkhead thread M 24x2 is fixed in size and needs no adaptor

Applications

Compressed air installation on machines and plants, water and cooling circuits, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.