Cutting ring fitting, elbow design, thread M 6 (konisch), tube 6 LL (M10x1), zinc plated steel

This cutting ring fitting joins the male thread M 6 (konisch) and a tube 6 LL (M10x1) in one part. The operating pressure reaches up to 100 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The very light series with the code LL follows the dimension series to ISO 8434-1
• The change of direction by 90 degrees saves installation length ahead of the port
• The cutting ring bites into the tube wall and holds the tube even under pressure surges
• The connection over male thread M 6 (konisch) is fixed in size and needs no adaptor
• With tube connection 6 LL (M10x1) the size is fixed, so no reworking of the line is required
• The operating pressure up to 100 bar is released for this size

Applications

Pipework on presses and pumps, repair of existing tube fittings, test benches and power unit construction, hydraulic lines in machine and plant engineering.

Standards and conformity

The tube fitting follows the design of cutting ring tube fittings to ISO 8434-1, formerly DIN 2353.