Weld-on tube fitting, elbow design, tube 6 L (M12x1.5), stainless steel 1.4571, NC clamping ring

This weld-on tube fitting is designed for a tube 6 L (M12x1.5) and a weld nipple of 10 mm outside diameter. The part clamps the cutting ring onto the tube and seals metal to metal. The operating pressure reaches up to 315 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The operating pressure up to 315 bar is released for this size
• The temperature range from -60 °C to +400 °C covers cold installation and warm machine surroundings
• The material stainless steel 1.4571, NC clamping ring stays resistant without additional coating in the range from -60 °C to +400 °C
• The light series with the code L follows the dimension series to ISO 8434-1
• The change of direction by 90 degrees saves installation length ahead of the port

Applications

Pipework on presses and pumps, repair of existing tube fittings, test benches and power unit construction, hydraulic lines in machine and plant engineering.

Standards and conformity

The tube fitting follows the design of cutting ring tube fittings to ISO 8434-1, formerly DIN 2353.