Weld-on tube fitting, elbow design, tube 12 S (M20x1.5), weld nipple 17 mm, phosphated steel

The weld-on tube fitting brings a tube 12 S (M20x1.5) and a weld nipple of 17 mm outside diameter together. The operating pressure reaches up to 630 bar. The elbow design turns the line by 90 degrees and saves installation length.

Benefits

• The temperature range from -40 °C to +120 °C covers cold installation and warm machine surroundings
• Phosphated steel carries the load of the joint in the range from -40 °C to +120 °C
• The heavy series with the code S follows the dimension series to ISO 8434-1
• The change of direction by 90 degrees saves installation length ahead of the port
• The weld nipple has a wall thickness of 4.5 mm and can be welded all round
• The cutting ring bites into the tube wall and holds the tube even under pressure surges

Applications

Repair of existing tube fittings, test benches and power unit construction, hydraulic lines in machine and plant engineering, pipework on presses and pumps.

Standards and conformity

The tube fitting follows the design of cutting ring tube fittings to ISO 8434-1, formerly DIN 2353.