Pre-assembly supports for stainless steel cutting ring - Riegler K1864

Pre-assembly supports for stainless steel cutting ring. This range covers 10 variants from 18.16 EUR. Select the version you need above.

Available variants

Shared technical data

About Pre-assembly adapters

Pre-assembly supports are hardened tool bodies in which the cutting ring is pre-set onto the tube before the actual fitting is made up. With stainless steel tube this intermediate step is required, since pre-assembly directly in the stainless fitting body should be avoided. The range covers threads from M8x1 to M30x2 for tube outside diameters of 4 to 22 mm.

What matters when choosing

• Thread: M8x1 up to M30x2 male. The support has to match the thread of the fitting that will be used later.
• Tube O.D.: 4 to 22 mm. Thread and tube size belong together, M16x1.5 for instance goes with 10 mm tube.
• PN: 100 to 315 bar. Sizes M8x1 to M12x1 are rated at 100 bar, the remaining sizes at 315 bar.
• Material: hardened steel 1.7227 across the range, so the cone survives repeated pre-assembly.
• SW: spanner sizes run from 10 to 24 and decide which tool has to be at hand at the pre-assembly station.

Typical applications

• Pre-setting cutting rings on stainless steel tube in hydraulic manufacturing
• Pipework on machine tools and presses
• Power unit and control cabinet building where tube is cut to length on site
• Maintenance of hydraulic systems with frequent tube changes
• Workshop equipment at the pre-assembly device or in a vice

The supports are made of steel 1.7227 and produced in Germany. The cones wear over time and therefore have to be checked at regular intervals.