Push-in fitting, tee design, male thread R 1/8", tube 8 mm, stainless steel

The push-in fitting brings the male thread R 1/8" and a tube of 8 mm outside diameter together. The operating pressure reaches from -0.95 bar to 18 bar. The tee design sets a branch at right angles onto the main line.

Benefits

• The operating pressure from -0.95 bar to 18 bar is released for this size
• The temperature range from -15 °C to +110 °C covers cold installation and warm machine surroundings
• The material stainless steel stays resistant without additional coating in the range from -15 °C to +110 °C
• One part serves two outlets and saves additional joints
• The seal in NBR is matched to the range from -15 °C to +110 °C
• The tube is pushed in without tools and released again over the release ring

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.