Push-in fitting, tee design, male thread R 1/4", tube 10 mm, nickel plated brass, -20 bis +70 °C

This push-in fitting joins the male thread R 1/4" and a tube of 10 mm outside diameter in one part. The operating pressure reaches from -0.95 bar to 15 bar. The tee design sets a branch at right angles onto the main line.

Benefits

• One part serves two outlets and saves additional joints
• The seal in NBR is matched to the range from -20 °C to +70 °C
• The tube is pushed in without tools and released again over the release ring
• The connection over male thread R 1/4" is fixed in size and needs no adaptor
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 15 bar is released for this size

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.