Push-in fitting, tee design, large design, male thread G 3/4", tube 28 mm, brass and POM

The push-in fitting accepts the male thread G 3/4" and a tube of 28 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is brass and POM, the size is fixed at tube diameter 28 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• Approvals to NSF and ANSI 51 as well as 61, DVGW-W270, KTW are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 28 is clearly assigned and stays available for reordering
• The connection over male thread G 3/4" is fixed in size and needs no adaptor

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.