Push-in fitting, tee design, male thread G 1/2", tube 12 mm, nickel plated brass, -20 bis +150 °C

The push-in fitting brings the male thread G 1/2" and a tube of 12 mm outside diameter together. The operating pressure reaches from -0.95 bar to 15 bar. The tee design sets a branch at right angles onto the main line. The version is fixed with -20 bis +150 °C.

Benefits

• The operating pressure from -0.95 bar to 15 bar is released for this size
• The temperature range from -20 °C to +150 °C covers cold installation and warm machine surroundings
• Nickel plated brass as material covers the released range from -20 °C to +150 °C
• One part serves two outlets and saves additional joints
• The seal in NBR is matched to the range from -20 °C to +150 °C
• The tube is pushed in without tools and released again over the release ring

Technical data

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.