Push-in fitting, tee design, tube 6 mm, second port 4 mm, nickel plated brass, -20 bis +80 °C

The push-in fitting brings a tube of 6 mm outside diameter and a second tube of 4 mm outside diameter together. The temperature range reaches from -20 °C to +80 °C. The tee design sets a branch at right angles onto the main line.

Benefits

• Nickel plated brass as material covers the released range from -20 °C to +80 °C
• One part serves two outlets and saves additional joints
• The transition from 6 mm to 4 mm saves an additional reducer
• The design standard is clearly designated in the data sheet
• The seal in NBR is matched to the range from -20 °C to +80 °C
• The tube is pushed in without tools and released again over the release ring

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.