Push-in fitting, tee design, tube 4 mm, second port 4 mm, PVDF, seal FKM

This push-in fitting joins a tube of 4 mm outside diameter and a second tube of 4 mm outside diameter in one part. The material is PVDF, the size is fixed at tube diameter 4 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• With tube diameter 4 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering

Applications

Compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.