Push-in fitting, tee design, large design, tube 28 mm, second port 28 mm, brass and POM

The push-in fitting accepts a tube of 28 mm outside diameter and a second tube of 28 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is brass and POM, the size is fixed at tube diameter 28 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 28 is clearly assigned and stays available for reordering
• With tube diameter 28 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.