Push-in fitting, tee design, tube 16 mm, stainless steel 1.4404

This push-in fitting joins a tube of 16 mm outside diameter and the continuing line in one part. The operating pressure reaches from -0.95 bar to 10 bar. The tee design sets a branch at right angles onto the main line.

Benefits

• Approvals to FDA are documented for the materials
• The seal in FKM is matched to the range from -15 °C to +120 °C
• The tube is pushed in without tools and released again over the release ring
• With tube diameter 16 mm the size is fixed, so no reworking of the line is required
• The operating pressure from -0.95 bar to 10 bar is released for this size
• The temperature range from -15 °C to +120 °C covers cold installation and warm machine surroundings

Applications

Pneumatic cylinders and valve terminals, control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants.

Standards and conformity

The following approvals are documented for the materials used: FDA. Only silicone free seals and lubricants are used during assembly.