Push-in fitting, tee design, large design, tube 15 mm, second port 15 mm, POM

The push-in fitting accepts a tube of 15 mm outside diameter and a second tube of 15 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is POM, the size is fixed at tube diameter 15 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 15 is clearly assigned and stays available for reordering
• With tube diameter 15 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints

Applications

Workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals, control air lines inside the control cabinet.

Standards and conformity

The following approvals are documented for the materials used: NSF and ANSI 51 as well as 61, DVGW-W270, KTW.