Push-in fitting, tee design, tube 10 mm, polypropylene, FDA compliant

The push-in fitting brings a tube of 10 mm outside diameter and the continuing line together. The material is polypropylene, FDA compliant, the size is fixed at tube diameter 10 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• The design polypropylene is clearly designated in the data sheet
• Approvals to FDA are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 10 is clearly assigned and stays available for reordering
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints

Technical data

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: FDA.