Push-in fitting, tee design, with EPDM seal, tube 10 mm, POM, FDA compliant

The push-in fitting accepts a tube of 10 mm outside diameter and the continuing line. The part accepts the tube without tools and holds it by the gripping claws. The operating pressure reaches from -0.95 bar to 11 bar. The tee design sets a branch at right angles onto the main line.

Benefits

• One part serves two outlets and saves additional joints
• Approvals to FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61 are documented for the materials
• The seal in EPDM is matched to the range from -0.95 bar to 11 bar
• The tube is pushed in without tools and released again over the release ring

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, FDA 21 CFR 177.2470, NSF and ANSI 51 as well as 61.