Push-in fitting, tee design, tube 10 mm, second port 6 mm, nickel plated brass

The push-in fitting accepts a tube of 10 mm outside diameter and a second tube of 6 mm outside diameter. The part accepts the tube without tools and holds it by the gripping claws. The material is nickel plated brass, the size is fixed at tube diameter 10 mm. The tee design sets a branch at right angles onto the main line.

Benefits

• The tube is pushed in without tools and released again over the release ring
• The size 10 is clearly assigned and stays available for reordering
• With tube diameter 10 mm the size is fixed, so no reworking of the line is required
• One part serves two outlets and saves additional joints

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, water and cooling circuits.

Standards and conformity

Only silicone free seals and lubricants are used during assembly.