T-pivot fitting, O-ring, G 3/8 o., hose 6/4, nickel-plated brass - Riegler 110619

T-pivot fitting, with O-ring, G 3/8 o., for hose 6/4 mm, AF 19, Working pressure max. 18 bar, nickel-plated brass

Standards and origin

• Customs tariff number: 74122000
• Country of origin: IT

About Banjo tees

A T-pivot fitting brings two tube runs together at one male thread and can be swivelled into the required direction during installation. The O-ring on the thread does the sealing. All 15 items are rated for a working pressure up to 18 bar.

What matters when choosing

• Thread: M5, G 1/8, G 1/4, G 3/8 or G 1/2 male. The female thread in the cylinder end cap or valve decides the size.
• For tube O.D. 5 to 12 mm and for hose I.D. 3 to 10 mm. The two figures belong together and are quoted as a pair, for example 6/4 mm or 10/8 mm.
• Working pressure: 18 bar maximum across the range. Anything above that rules this group out.
• Material: nickel-plated brass with an NBR seal. That pairing suits compressed air, not media that attack NBR.
• Operating temperature: -20 °C to 80 °C, the same for every item in the group.

Typical applications

• Connecting pneumatic cylinders where the tube direction is only fixed at the machine
• Twin outlets on valve terminals and air service units
• Tight installation spaces in fixtures and handling equipment
• Grippers and clamps with moving tube runs
• Retrofits where a second consumer has to share an existing port

All 15 items are made of nickel-plated brass with an NBR seal and are produced in Italy.