Mist lubricator, G 3/8", 0 - 16 bar, zinc die casting Z410, plastic bowl with protective cage

This mist lubricator stands at the end of the air treatment and supplies the downstream consumers with oil mist. The connection is made via thread G 3/8". The material used is zinc die casting Z410. The inlet pressure covers 0 - 16 bar. The temperature range extends over -10 to +60 °C.

Benefits

• Oil reservoir 40 cm³ for long refilling intervals
• Height 169 mm and length 50 mm for installation planning
• Inlet pressure 0 - 16 bar as the leading rating of the device
• Connection thread G 3/8" for direct installation in the line
• Temperature range -10 to +60 °C for use in the workshop and in the plant
• Flow rate 50 - 1250 l/min without any appreciable pressure drop in the line

Applications

Air tools, impact wrenches and chisel hammers, pneumatic drives with a high switching frequency.

Standards and conformity

The data sheets refer to Richtlinie 2014/34/EU. Further approvals are not documented and are therefore not stated.