Hexagon head bolt DIN 931 / ISO 4014, M 10x140, hexagon 17 mm, shank 108 mm, stainless steel A2

Plants that are washed down regularly call for resistant fasteners. This hexagon head bolt M 10x140 to DIN 931 made of stainless steel A2 meets that requirement without any coating. Of the 140 mm total length, 32 mm are threaded and 108 mm stay plain. The hexagon with 17 mm across flats can still be engaged after a long service life.

Advantages

• Thread length of 32 mm to DIN 931, sufficient for a nut and a washer in size M 10.
• Plain shank of 108 mm within 140 mm of total length, which places the shear plane in the full shank cross section instead of the thread.
• Head height of 6.4 mm keeps the overall height of the joint low.
• Hexagon head with 17 mm across flats, so the tightening torque can be applied with an ordinary open-ended or ring spanner.
• Stainless steel A2 stays bright under moisture and wash water, so an additional coating is not needed.

Applications

Conveying and plant equipment where joints in size M 10 are undone regularly. Bolting of profile frames and cross beams over a clamping range up to 140 mm. Mounting of guide rails and stops with a fitted hole for the shank. Joints where the width across flats of 17 mm has to match the available tools.

Standards and conformity

The bolt is dimensioned to DIN 931 and ISO 4014. The width across flats is 17 mm to DIN 931 and 16 mm to ISO 4014. The material is stainless steel A2.