Push-in fitting, bulkhead design, with female thread, male thread G 1/8", tube 4 mm, stainless steel

The push-in fitting brings the male thread G 1/8" and a tube of 4 mm outside diameter together. The material is stainless steel, the size is fixed at tube diameter 4 mm. The bulkhead design leads the line tightly through a panel or wall.

Benefits

• The bulkhead panel may be up to 4 mm thick
• Approvals to FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61 are documented for the materials
• The tube is pushed in without tools and released again over the release ring
• The size 4 is clearly assigned and stays available for reordering
• The connection over male thread G 1/8" is fixed in size and needs no adaptor
• With tube diameter 4 mm the size is fixed, so no reworking of the line is required

Applications

Control air lines inside the control cabinet, workshop distribution and service units, compressed air installation on machines and plants, pneumatic cylinders and valve terminals.

Standards and conformity

The following approvals are documented for the materials used: FDA 21 CFR 177.2600, NSF and ANSI 51 as well as 61.